Audio Controller; Beep Volume; Lan/Lan 0 Remote Boot - Load Operating System Via Lan - Fujitsu D2912 Bios Manual

Advanced Menu – Advanced system configuration

Audio Controller

If the audio controller is equipped on the mainboard, it can be switched on or off.
All audio controllers are enabled. The system BIOS determines which system
Enabled
resources (interrupts, addresses, DMAs) are occupied.
The onboard audio controller is disabled.
Disabled
Front Panel Audio
Enables use of an AC97 front audio connector. In this setting the automatic occupancy
detection for the audio sockets is not supported.
For use of a high definition audio cable with automatic occupancy detection.
High
definition
For use of a legacy audio cable without automatic occupancy detection.
Legacy

Beep Volume

The volume of the system board beep tone can be adjusted here.
increases the volume of the beep.
High
decreases the volume of the beep.
Low
switches off the beep tone.
Off
LAN/LAN 0 Remote Boot – Load operating system via LAN
enables the operating system to be loaded from a server. This function is used in particular when
neither floppy disk nor hard disk drives are installed, or these have been disabled.
Enabled
Disabled
22
LAN remote boot is activated and allows the operating system to be loaded
from a server via a local network connection.
LAN Remote Boot is deactivated.
Fujitsu Technology Solutions