Peripheral Configuration - Ports And Controllers; Serial 1/Serial 2 - Serial Ports; Parallel Port (System-Dependent) - Fujitsu D2912 Bios Manual

Advanced Menu – Advanced system configuration
Peripheral configuration – Ports and controllers
Controller Port Peripheralconfiguration
Opens the submenu used to adjust settings for ports and controllers.
Peripheral Configuration
Serial 1:
Serial 2:
Parallel port:
Diskette Controller:
USB Host Controller:
USB Devices:
USB Ports:
USB BIOS Hot-Plug:
Audio Controller:
Beep Volume:
LAN Remote Boot:
Example showing the Peripheral Configuration menu
Serial 1/Serial 2 – Serial ports
This field selects the address and the interrupt used to access the corresponding serial port.
The serial port is set to the indicated address and interrupt. If you select Enabled,
Enabled
additional lines are displayed for the configuration settings.
The serial port is disabled.
Disabled
The serial interface will be selected automatically by the BIOS or operating system.
Auto

Parallel port (system-dependent)

Sets the address and interrupt for access to the parallel port.
The parallel port is set to the address and the interrupt shown here. If Enabled is
Enabled
selected, additional lines are displayed for setting the configuration.
The parallel port is automatically set to the next available combination (address,
Auto
interrupt).
The parallel port is disabled.
Disabled
20
[Auto]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[All]
[Enabled]
[Enabled]
[Enabled]
[High]
[Enabled]
Item Specific Help
Configure serial port
using options
[Disabled]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
Fujitsu Technology Solutions