Smartcard Systemlock/Systemlock 2 (Optional) - Fujitsu D2912 Bios Manual

SmartCard SystemLock/SystemLock 2 (optional)

SmartCard SystemLock
SmartCard SystemLock
Install Single PC:
Install Group PC:
Switchingon the system SmartCard
With SystemLock enabled, the PC can only be started using an initialised SmartCard (SICRYPT,
CardOS or Fujitsu) and a personal identification number (PIN). SmartCard and PIN are checked
by the BIOS during system boot, i.e. before the operating system is loaded.
All new SmartCards have a preset PIN (Personal Identification Number)
and PUK (Personal Unblocking Key).
On SICRYPT and CardOS SmartCards, PIN and PUK are preset to 12345678.
On Fujitsu cards, the PIN is preset to 0000 and the PUK is preset to administrator.
We recommend that you change both PIN and PUK for security reasons.
Additional software (e.g. Smarty) is required in order to allow the system to also check
that the correct SmartCard is inserted when the system is running.
If BIOS-Setup does not list the entry SmartCard SystemLock in the Security menu, then your
system does not support SystemLock. You can update your system BIOS using Flash BIOS
update (see Chapter
After you have initialised one SmartCard, it will not be possible to deactivate the
SmartCard SystemLock entry (Disabled) in BIOS Setup. Please refer to
SystemLock", Page 54
Fujitsu Technology Solutions
"BIOS update of USB stick or diskette", Page
for how to uninstall SystemLock.
Not Installed
[Enter]
[Enter]
Security Menu - Security features
Item Specific Help
Installs the security
for this PC, and
creates a new
SystemLock Admin
SmartCard dedicated to
this PC.
SmartCard data will be
overwritten.
A correct SmartCard is
required for a
permanent installation
63).
"Uninstall
43