Current Tpm State; Tpm Physical Presence Operations; Virus Warning - Fujitsu D2912 Bios Manual

Security Menu - Security features

Current TPM State

Indicates the current state of the Trusted Platform Module (TPM).
Disabled and Activated
Disabled and Deactivated
Enabled and Activated
Enabled and Deactivated

TPM Physical Presence operations

This Setup page cannot be accessed via the normal BIOS Setup. It is displayed automatically
during the BIOS POST process if it necessary to make a change to the TPM configuration.
It can be initiated either by BIOS Setup or via an operating system with TPM support. The
Trusted Computing Group (TCG) security provisions stipulate that configuration changes
must be confirmed again by the operator (Physical Presence operations).
Physical Presence Operations
TPM Configuration change was requested to
State:
Note:
This action will switch on the TPM
Reject
Execute
Possible settings:
Enable & Activate
Deactivate & Disable
Clear

Virus Warning

Bootsector Viruswarning Computer viruses
Checks the boot sectors of the hard disk drive to see if any changes have been made since
the previous system start-up. If the boot sectors have been changed and the reason for this
is unknown, a suitable computer virus detection program should be run.
A warning will be displayed if the boot sector has been changed since the previous
Enabled
system start-up (e.g. new operating system or virus attack). The warning will stay
on the screen until you acknowledge the changes with Confirm or deactivate the
function (Disabled).
This entry confirms a required change to a boot sector (e.g. new operating system).
Confirm
The boot sectors are not checked.
Disabled
56
Enabled and Activated
Item Specific Help
Reject Physical
Presence operations and
exit
Fujitsu Technology Solutions