Switching On The Pc With Systemlock; Change Pin; Uninstall Systemlock - Fujitsu D2912 Bios Manual

Security Menu - Security features

Switching on the PC with SystemLock

If you have an internal SmartCard reader, then you can switch on the PC by inserting the SmartCard.
If you switch on the PC using the ON/OFF switch, then the following message will appear:
Insert a SmartCard.
SystemLock
► Insert your SmartCard.
Enter PIN:
► Enter your PIN.
The following message will be displayed:
• ACCESS DENIED = You have entered an incorrect PIN. After three failed attempts, the
SmartCard will be blocked and can only be enabled again by entering the PUK.
Depending on the rights assigned to your SmartCard, you can select the following
functions when this message is displayed on the screen:
F2=Setup, F3=Change PIN
If your SmartCard has the appropriate rights, you can:
F3,function key F2,function key
F2 – Open BIOS Setup.
F3 – Change the PIN.
If you do not select a function, the system will boot up.
Start BIOS Setup –
A SmartCard with the appropriate rights must be inserted (SuperUser, Service or Admin).

Change PIN

Available for every initialised SmartCard.
► Press function key
F3,function key PIN,changing
► Enter the old PIN.
► Enter the new PIN.
4 to 8 digit numbers are acceptable for the new PIN.
For security reasons, we recommend that you change the PIN for every
SmartCard and use an 8-digit number each time.
► Confirm the new PIN.

Uninstall SystemLock

► Start the PC.
► Follow the instructions as described in Section
Page 51. Select "Uninstall" to uninstall SystemLock.
You can now use the PC again without the need for a SmartCard.
54
F2
.
F3
"Carrying out administrator functions",
Fujitsu Technology Solutions