Table of Contents
Advertisement
Operation
This section describes how to operate the ATV/Motorcycle Lift safely during normal operation.
Safety Rules
Important:
To use your ATV/Motorcycle Lift safely:
• Every time, before raising a Vehicle, inspect the Lift. Check for kinked hoses, worn or missing
parts, or any other abnormalities. If you see anything wrong, take the Lift out of service,
disconnect it from its air supply, and then contact an authorized repair facility, your distributor,
or BendPak Ranger by phone at (805) 933-9970 or by email at support@bendpak.com.
• The Concrete on which the Lift is installed is to be level and in good condition (free of defects).
• Check the area around, under and above the Lift for obstructions; anything that might block the
Lift from going up or going down normally. If you find an obstruction, move it out of the way.
• Center and secure the Vehicle on the Lift before raising.
• Keep all body parts and objects away from pinch points when Lift is in motion. Take care to
ensure that the pump is not under the Top Deck to prevent the deck from crushing your foot
while operating the Pump.
• If your organization has Lockout/Tagout policies, make sure to implement them once the Lift is
connected to an air supply. Never exceed air line pressure ratings.
• The Pump is a tripping hazard if you keep it on the ground. Make sure everyone who uses the
Lift or works near it is aware of the location of the Pump.
• Only allow trained, supervised personnel to operate the Lift. Do not allow children or untrained
personnel to operate the Lift. Do not let anyone under the influence of drugs, alcohol, or
medication to operate the Lift.
• Other than the person operating the Lift, keep all other people a minimum of 30 feet away
from the Lift while it is being used.
⚠
WARNING
• Never exceed the Lift's weight rating. Do not allow people inside a Vehicle you are going to
raise. Before raising a Vehicle, make sure it is centered, balanced and secure on the Top Deck.
• Always walk a Vehicle onto the Lift. Never drive the Vehicle onto the Lift.
• If the Lift seems to be having difficulty raising a Vehicle, stop operation immediately, lower the
Lift down to the ground, check the Lift and review the published weight of the Vehicle and
make any necessary adjustments, then try again.
• Do not begin work until the Lift is fully lowered or engaged on Safety Locks. Visually confirm the
Lock Position and verify the load is centered, balanced and secure.
RML-1500XL ATV / Motorcycle Lift
Your safety is dependent on reading, understanding, and implementing these
Safety Rules. Do not skip over them; read them carefully and follow them!
Operators must wear OSHA-approved (publication 3151) Personal Protective
Equipment at all times when installing, using, maintaining, or repairing the Lift.
Leather gloves, steel-toed work boots, ANSI-approved eye protection, back belts,
and hearing protection are mandatory.
25
P/N 5900183 — Rev. E2 — May 2022
Advertisement
Table of Contents
