Table of Contents
Advertisement
• ATV Configuration. This configuration is wider and will function with both ATVs and
Motorcycles. The only drawback to using the ATV configuration for Motorcycles is that you
cannot get as close to the sides of the Motorcycle as you can when in the Motorcycle
configuration.
To install the Lift in ATV Mode, add the Extension Tubes, Side Extensions and Ring Pins on both
sides of the Top Deck, the Front Extension over the front of the Top Deck, and the two Ramps.
Refer to the figure below.
The procedures in this Manual assume you are installing the Lift in an ATV configuration. If you are
installing the Lift for Motorcycle service, ignore the instructions for components that are only used
in the ATV configuration.
RML-1500XL ATV / Motorcycle Lift
17
P/N 5900183 — Rev. E2 — May 2022
Advertisement
Table of Contents
