Ranger RML-1500XL Installation And Operation Manual page 29

Using the Casters
The Lift has built-in Casters, making it easy to move the Lift to different locations.
To move the Lift using the Casters:
Retrieve a 10 mm hex key.
Locate the four Caster Adjustment Rods on the Base of the Lift.
The two Caster Adjustment Rods are under the Drive-Up Ramps, if installed.
Turn each of the four Caster Adjustment Rods clockwise to engage the Casters.
The Base rises slightly as the Casters engage.
When all four Casters are engaged, carefully roll the Lift to the desired location.
When the Lift is at the desired location, turn each of the four Caster Adjustment Rods
counterclockwise to lower the Base back down onto the ground.
⚠
WARNING
⚠
WARNING
RML-1500XL ATV / Motorcycle Lift
Verify the Lift Casters are retracted and the Lift cannot move on its Casters
before raising a Vehicle at the new location. Lifting a Vehicle while the Lift is on
its Casters is dangerous and may cause the Vehicle to shift or fall off of the Lift.
Damage to property and injury to personnel may occur.
Verify the Lift is level at the new location. The concrete surface should not
exceed 3° of slope whenever operating the Lift.
29
P/N 5900183 — Rev. E2 — May 2022