Ranger RML-1500XL Installation And Operation Manual page 30

Using the Stand Poles
The Stand Poles are powder coated and include Hooks to assist in rigging, tie off and lifting the rear
end of ATVs and Motorcycles.
To use the Stand Poles simply insert the Poles into the two openings at the rear of the Lift near the
Movable Deck Plate. Refer to the Figure below.
Lubrication
Light lubrication on a monthly basis or on an "as required" basis with frequent use is
recommended. Use a White Lithium Grease on the Frame in the areas where the Scissor Rollers
travel and on the Scissor Hinge points. Refer to the figure below.
30
RML-1500XL ATV / Motorcycle Lift P/N 5900183 — Rev. E2 — May 2022