Ranger RML-1500XL Installation And Operation Manual page 14

Unpack the Components
Use caution when unpacking Lift components. You do not want to damage or misplace anything.
Tip
To unpack the Lift components:
Move the box holding the Lift as close as possible to where it will be used.
Use appropriate tools to remove the top of the box.
The Air/Hydraulic Pump is delivered in a separate box; remove that from its box as well.
Remove all of the components except the Base/Top Deck.
Remove the bubble wrap from around those components that are wrapped; lay them out near
where you are going to set up the Lift.
Locate the plastic bag that holds the Nuts, Bolts, Washers, and the other items you are going to
need during installation.
BendPak Ranger recommends carefully laying them out near where you are going to install the
Lift so that they are easily accessible when needed.
Find the Hydraulic Hose coming from between the Base and the Top Deck and connect it to the
Hydraulic Connector on the side of the Air/Hydraulic Pump.
The Hydraulic Hose comes already connected to the Hydraulic Cylinder. You only need to
connect it to the Hydraulic Quick Connector on the Air/Hydraulic Pump. Refer to the figure
below.
RML-1500XL ATV / Motorcycle Lift
Consider unpacking the components in the area where you are going to set up the Lift.
The fewer times you move the components, the fewer opportunities there are for
them to get lost, get damaged, or damage the surface they are on.
14
P/N 5900183 — Rev. E2 — May 2022