Ranger RML-1500XL Installation And Operation Manual page 16

Configure the Lift
The Lift may be configured to service Motorcycles or All-Terrain Vehicles (ATV).
• Motorcycle Configuration. This configuration is not wide enough to accommodate ATVs.
To install the Lift in the Motorcycle service configuration, install the Movable Deck Plate, the
two Ramps, then bolt the Tire Vise Assembly onto the front of the Top Deck. Refer to the figure
below.
Note: If you want you use the Lift configured for Motorcycle service, you will still require the two
Drive-Up Ramps to be installed.
If you are configuring for Motorcycle service, do not install the Side Extensions or the Front
Extension. You will also not need to use the Extension Tubes.
If you are configuring the Lift for Motorcycle service, you will have components left over (Side
Extensions, Extension Tubes, Ring Pins and the Top Deck Extension. BendPak Ranger
recommends keeping them in a dry location protected from damage, in case you want to switch
to ATV service in the future.
RML-1500XL ATV / Motorcycle Lift
16
P/N 5900183 — Rev. E2 — May 2022