Table of Contents
Advertisement
Connect to a compressed air supply (40-120 psi at 105 in
to the 1/4-18 NPT input on the Pump. Refer to the previous figure.
⚠
WARNING
Step down on the pedal where it is labelled PUMP to raise the Lift. Continue to step on the
pedal until the Lift reaches full rise (≈45.4 in. / 1153 mm) then remove your foot from the
pedal.
As the Top Deck rises, the Safety Lock Plate falls into each Safety Lock Ladder position; you hear
an audible clank when this happens. This is normal operation; it also gives you a clear indication
that the Top Deck is rising normally and lets you know when a Safety Lock has been passed.
Put a Lifting Strap around the middle of the Top Deck, then use a Forklift or Shop Crane (or
other appropriate lifting device) to raise the Lift up and then move it away from away from the
Shipping Box or remove the shipping box.
⚠
WARNING
Move the Shipping Box away from the area
where you are setting up the Lift; it is a
tripping hazard.
Use your foot to step on the Pedal section
labelled RELEASE to lower the Lift until it
engages on the top Safety Lock.
⚠
CAUTION
RML-1500XL ATV / Motorcycle Lift
This Lift uses pneumatic (air) energy; if your organization has Lockout/Tagout
policies, implement them once the Lift is connected to a pressurized Air Supply.
Only allow trained personnel
to put the Strap in position or
use the lifting device. Be
careful moving the Lift; it is
heavy and awkward. Take
your time and be safe. If the
Lift falls, it could damage the
Lift or injure anyone nearby.
Always leave the Lift either
fully lowered or engaged on a
Safety Lock.
3
) using appropriate fittings to connect
15
P/N 5900183 — Rev. E2 — May 2022
Advertisement
Table of Contents
