Operation - Ranger RML-1500XL Installation And Operation Manual

Atv/motorcycle lift
Hide thumbs Also See for RML-1500XL:
Table of Contents

Advertisement

Operation

This section describes how to use the ATV/Motorcycle Lift safely during normal operation.
Safety Rules
Important:
To use your ATV/Motorcycle Lift safely:
• Before raising a vehicle, inspect the Lift every time. Check for kinked hoses, worn or missing
parts, or any other abnormalities. If you see anything wrong, take the Lift out of service,
disconnect it from its air supply (if connected), and then contact an authorized repair facility,
your distributor, or BendPak Ranger by phone at (805) 933-9970 or by email at
support@bendpak.com.
• Check the area around the Lift for obstructions; anything that might block the Lift from going up
or going down normally. Do not forget to check above the Lift. If you find an obstruction, move
it out of the way.
• The Lift uses pneumatic (air) energy; if your organization has Lockout/Tagout policies, make
sure to implement them once the Lift is connected to a pressurized air supply.
• The Pump is a tripping hazard if you keep it on the ground. Make sure everyone who uses the
Lift or works near it is aware of the location of the Pump.
• Only allow trained, supervised personnel to operate the Lift. Do not allow children or untrained
personnel to operate the Lift. Do not let anyone under the influence of drugs, alcohol, or
medication to operate the Lift.
• Other than the person operating the Lift, keep all other people a minimum of 30 feet away
from the Lift while it is being used.
WARNING
• Never exceed the Lift's weight rating. Do not allow people inside a Vehicle you are going to
raise. Before raising a vehicle, make sure it is balanced and secure on the Platform.
• Do not drive the vehicle onto the Lift.
• If the Lift seems to be having difficulty raising a vehicle, stop operation immediately, lower the
Lift back down to the ground, check everything out and make any necessary adjustments, then
try again.
• Only leave the Lift if it is fully lowered or engaged on Safety Locks.
• Do not begin work on the vehicle on the Lift until you are sure the Lift is engaged on a Safety
Lock and the vehicle is balanced and secure on the Lift.
• Pay attention at all times while using the Lift. Safety is your top priority at all times.
RML-1500XL ATV / Motorcycle Lift
Your safety is dependent on reading, understanding, and implementing these
Safety Rules. Do not skip over them; read them carefully and follow them!
Operators must wear OSHA-approved (publication 3151) Personal Protective
Equipment at all times when installing, using, maintaining, or repairing the Lift.
Leather gloves, steel-toed work boots, ANSI-approved eye protection, back belts,
and hearing protection are mandatory.
18
P/N 5900183 — Rev. E — Feb. 2020

Advertisement

Table of Contents
loading

Table of Contents