Table of Contents
Advertisement
• Base. The bottom section of the Lift. It includes the Adjustment Rods, the Safety Lock Plate, the
Safety Locks, Lift Cylinder and the Ramps.
• Safety Lock Release Handle. Controls the location of the Safety Lock Plate. When in the Lock
position, lowering the Lift engages the Lift on a Safety Lock. When in the Release position,
lowering the Lift moves the Lift all the way to the ground.
• Safety Stop Ladder. Hold the Lift in position at the desired height once engaged.
• Safety Lock Assembly. The part of the Lift that engages on the Safety Locks.
• Hydraulic Cylinder. Raises and Lowers the Top Deck using hydraulic energy from the
Air/Hydraulic Pump.
• Drive-Up Ramps. Two ramps, wide enough (when both are installed) to accommodate ATVs.
• Air/Hydraulic Pump. Uses pneumatic (air) power to provide hydraulic power to raise the Lift. If
you have a pressurized air supply available (40 to 120 psi at 105 in
Pump to raise the Lift.
• Stand Poles. Tall poles on the Ramp end of the Lift that provide anchor points to assist in
rigging, tie-downs and lifting the Motorcycle or ATV on the Top Deck.
• Top Deck Side Extension Tubes and Ring Pins. Three long Rods that support and connect the
Top Deck Side Extensions and the Front Extension to the Top Deck. Each Connecting Rod has a
Ring Pin on each end (to lock the tube in place).
RML-1500XL ATV / Motorcycle Lift
8
3
), you can connect it to the
P/N 5900183 — Rev. E2 — May 2022
Advertisement
Table of Contents
