Ranger RML-1500XL Installation And Operation Manual page 19

BendPak Ranger strongly recommends two people assemble the ATV/Motorocyle Lift. Many
components are heavy and the weight may be awkwardly distributed.
Refer to the figure on the previous and following pages during installation.
To install Lift components:
Install the Movable Deck Plate Assembly in place on the Top Deck at the Ramp end of the Lift.
This Deck Plate is not secured.
Slide the Top Deck Extension over the Top Deck at the opposite end of the Ramps.
You can easily identify this end of the Lift because it has the drilled holes used later to install
the Wheel Vise Assembly.
Align the holes in the side of the Front Extension with the holes in the side of the Top Deck.
Locate the three Top Deck Extension Tubes.
Push Two Extension Tubes through the holes in the sides of the Front Extension and Top Deck.
Refer to the figure below.
Do not scale. Components removed for clarity.
Locate two M10 x 25 Hex Head Bolts (5530738), Lock Washers (5545200), Flat Washers
(5545341) and Hex Nuts (5535013). Insert and secure as shown in the figure above.
Insert the third Side Extension Tube in the Top Deck opening near the Moveable Deck
Assembly. Refer to the figure below.
RML-1500XL ATV / Motorcycle Lift
19
P/N 5900183 — Rev. E2 — May 2022