Panasonic PT-40LC12 Service Manual page 126

10. 1) Peel off the Light Prevention Plate on the Projection
Unit.
2) Remove the Lamp from the Projection Unit.
CAUTION:
After removing the Projection Unit, take out the Light
Prevention Plate and the Lamp from the Projection Unit
once and keep them. Then, be sure to install the Light
Prevention Plate and the Lamp into the new Projection Unit
for replacement.
hole of the Light
Prevention Plate
slit of the Light
Prevention Plate
Lamp
Reassembly Notes for Light Prevention Plate:
1) Insert the hole of the Light Prevention Plate to the
Projection Lens while opening slit.
2) Contact it against the ring of the Projection Lens and
paste with double-sided adhesive tape as shown.
Projection Lens
adhesive tape
Lens
Light
Prevention
Plate
Fig. D2-9
Light
Prevention
Plate
Ring of Projection Lens
Fig. D2-10