10. Disconnect Connectors P2501, P2701, P2305 on the LCD
Main C.B.A. and release them from the clampers.
P2701
P2305
Clamper
11. 1) Disconnect Connector P804 on the TV Main C.B.A. by
pressing the Locking Tab of the P804 connector cable
and release it from the clamper.
2) Disconnect Connector P1101 on the Audio Power
C.B.A. and release it from the clamper.
3) Remove the Screw on the GND Plate.
4) Remove 3 Screws on the TV Frame.
Screw "a"
TV Frame
Screws "b"
P2501
Clamper
LCD Main C.B.A.
Fig. D1-10
GND Plate
Clampers
P804
Audio Power C.B.A.
Fig. D1-11
12. Lift up and slide the TV Frame straight out by releasing the
2 Tabs from holes, and disconnect Connector P7001 while
sliding the TV Frame at this time.
P7001
(GND Wire 1pin)
13. 1) Remove the Rear Jack Panel from the Rear Jack
P1101
2) Release the AC Cord by from the slot of the Rear Jack
Screw "c"
holes
Lift up and slide
Tab
<Bottom View of TV Frame>
Fig. D1-12
C.B.A. by removing the 7 Screws.
Panel.
Rear Jack Panel
Screw "c"
Screw "d"
Screw "d"
Screw "d"
Screw "d"
<Back of Rear Jack C.B.A.>
Fig. D1-13
Tab
Slot
AC Cord
Screw "d"