NEC Express5800 User Manual page 208

B-10 Installing the Operating System
9.
If the optional board is installed, select the proper SCSI Adapter and press Enter.
– LSI MegaRAID Software RAID (Windows XP/2003)
(When onboard LSI Logic Embedded MegaRAID(TM) controller is used.)
– Emulex LPX000 PCI Fibre Channel HBA
(When Fibre Channel controller (N8403-018) is used.)
– LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)
(When Disk Array Controller (N8403-019) is used.)
10.
When the following message is shown, press Enter to start "Welcome to Setup".
11.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
12.
When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be
displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows Setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after the
application of "System update". Be sure to install Microsoft
Windows Server 2003 R2 DISC 2. In this case, note that the
[Windows Setup] screen is not displayed.
13.
Insert Microsoft Windows Server 2003 R2 DISC 2 CD-ROM into the DVD-ROM drive.
Confirm the parameters and click [OK].
14.
When the installation has completed, remove Microsoft Windows Server 2003 R2 DISC 2
CD-ROM from the DVD-ROM drive, and restart the system.
15.
After installation is completed, be sure to execute the tasks described in "Setup of Device
Driver (Normally Installed in Server)" and "Updating the System" of this chapter.