Figure 31: BSBAC 1 HP drive take-up pulley bearing - motor side
10. Pull out the take-up pulley bearing on the non-motor side. Figure 32 illustrates this operation with
an exploded view.
1 HP take-up pulley
bearing – non-motor
Figure 32: BSBAC 1 HP drive take-up pulley bearing - non-motor side
11. Angle the take-up pulley so that the motor side end of the pulley is towards downstream and the
non-motor side end of the pulley is towards upstream of the conveyor. This is done by moving the
take-up bracket on both ends of the drive section in opposite directions. Figure 33 illustrates this
operation.
Published January 2022
Installation & Maintenance Manual: BSBAC 1 HP
side
Rev. B
1 HP take-up
pulley bearing –
37