Figure 21: Installing The Underside Cover To The Bsbac Bed Section - TOYOTA ADVANCED LOGISTICS Bastian SOLUTIONS BSBAC 1 HP Installation And Maintenance Manual

3. Raise the underside cover to the mating BSBAC section. Install the 3/8" carriage bolt and
serrated flange to the mounting holes at the bottom of the side frame of the BSBAC section.
Figure 21 illustrates the orientation of this operation. The torque requirement for the 3/8" carriage
bolt and serrated flange nut is 31 ft-lbs.

Figure 21: Installing the underside cover to the BSBAC bed section

4. If turnbuckles are required for the conveyor section, install the underside cover without tightening
the fasteners and then install the turnbuckles. After installing the turnbuckles and adjusting to the
straightness of the frame, torque down the fasteners for the underside covers.
Published January 2022
Installation & Maintenance Manual: BSBAC 1 HP
Rev. B
27