Device Settings; Calling Up The Setting Menu - JUMO 202710/30 Operating Manual

6.1

Calling up the setting menu

Overview of the setting menu
The setting menu is called up from measurement mode by pressing the
key for at least 2 seconds (main display "SEt").
The 5 individual submenus in the setting menu are then selected by repeatedly
pressing the
(6)
Measuring
Configuring
the device
Parameterizing
the device
Providing infor-
mation
a
Only possible if calibration data is stored in the device.
NOTE!
The configuration is stopped if no keys are pressed for over 2 minutes. Any
changes made up to this point will not be saved!
All manuals and user guides at all-guides.com
key.
Set
Menu
4
SAL mg/l kOhm mS µS
Store
Quit
Lin nLF AL Logg %/K 1/cm
6
Set
Menu
4
Store
Quit
6
(5)
SAL mg/l kOhm mS µS
Lin nLF AL Logg %/K 1/cm
(1) Display in measurement mode
(2) General settings, see page 20
(3) Settings for the serial output, see page 28
(4) Offset/zero point correction and slope correction of the tem-
perature measurement, see page 29
(5) Settings for the real-time clock, see page 30
(6) Read calibration data

6 Device settings

(2)
SAL mg/l kOhm mS µS
Set
Lin nLF AL Logg %/K 1/cm
Menu
4
Set
Store
Menu Quit
6
4
> 2 s > 2 s
(1)
SAL mg/l kOhm mS µS
Store
Quit
6
Lin nLF AL Logg %/K 1/cm
Store
Quit
6
SAL mg/l kOhm
Lin nLF AL Logg
Set
Menu
4
a
, see page 36
(3)
SAL mg/l kOhm mS µS
Lin nLF AL Logg %/K 1/cm
Set
Menu
4
(4)
mS µS
%/K 1/cm
19