Device Settings; Calling Up The Setting Menu - JUMO 202710 Operating Manual

8.1

Calling up the setting menu

Overview of the setting menu
The setting menu is called up from measurement mode by pressing the
key for at least 2 seconds (main display "SEt").
The 4 individual submenus in the setting menu are then selected by repeatedly
pressing the
Measuring
Configuring
the device
Parameterizing
the device
Providing
information
NOTE!
If no keys are pressed for over 2 minutes, the device setting is aborted.
Any changes made up to this point will not be saved!
All manuals and user guides at all-guides.com
key.
Set
Menu
4
(5)
rH mV mV pH
H
Store
Quit
6
ATC ok CAL AL Logg pH
Set
Menu
4
(1) Display in measurement mode
(2) General settings, See page 34
(3) Offset/zero point correction and slope correction of the voltage
input and the temperature input, See page 41
(4) Settings for the real-time clock, See page 43
(5) Read calibration data, See page 46

8 Device settings

( )
rH mV mV pH
H
ATC ok CAL AL Logg pH
Set
Store
Menu Quit
6
4
> 2 s > 2 s
(1)
rH mV mV pH
H
Store
Quit
6
ATC ok CAL AL Logg pH
Store
Quit
6
(4)
rH mV mV pH
H
ATC ok CAL AL Logg pH
Set
Menu
4
(3)
rH mV mV pH
H
ATC ok CAL AL Logg pH
Set
Menu
4
33