Device Settings; Calling Up The Setting Menu - JUMO 202710/30 Operating Manual

6.1

Calling up the setting menu

Overview of the setting menu
The setting menu is called up from measurement mode by pressing the
key for at least 2 seconds (main display "SEt").
The 5 individual submenus in the setting menu are then selected by repeatedly
pressing the key.
Set
Menu
4
(6)
SAL mg/l kOhm mS µS
Lin nLF AL Logg %/K 1/cm
Set
Menu
4
(5)
SAL mg/l kOhm
Lin nLF
Measuring (1) Display in measurement mode
Configuring (2) General settings, see page 20
the device
(3) Settings for the serial output, see page 28
Parameterizing (4) Offset/zero point correction and slope correction of the tem-
the device perature measurement, see page 29
(5) Settings for the real-time clock, see page 30
Providing infor-
(6) Read calibration data
mation
a
Only possible if calibration data is stored in the device.
NOTE!
The configuration is stopped if no keys are pressed for over 2 minutes. Any
changes made up to this point will not be saved!
SAL mg/l kOhm
Lin nLF AL Logg
Set
Menu
6
4
> 2 s > 2 s
SAL mg/l kOhm
Store
Quit
6
Lin nLF AL Logg
Store
Quit
6
mS µS
AL Logg %/K 1/cm
Set
Menu
4
a
, see page 36

6 Device settings

(2)
mS µS
Set
%/K 1/cm
Menu
4
Store
Quit
SAL
(1)
mS µS
Store
Quit
6
%/K 1/cm
Store
Quit
6
SAL mg/l kOhm mS µS
Lin nLF AL Logg %/K 1/cm
(3)
mg/l kOhm mS µS
Lin nLF AL Logg %/K 1/cm
Set
Menu
4
(4)
19