Table of Contents
Advertisement
10.9.7.2 Smart Thermostat
The smart thermostat function will adjust the flame height based
on the set temperature and the actual room temperature. The smart
thermostat function automatically adjusts the flame down when the
room temperature reaches the set point. To activate this function,
1.
Press the thermostat key until the 'SMART' appears on LCD
screen on the right side of the temperature bulb graphic.
2.
To adjust the set temperature, press the up or down arrow keys
until the desired temperature is displayed on the LCD screen.
10.9.7.3 Deactivate Remote Control
Thermostat Operation
The thermostat operation function can be deactivated. The remote
control will still operate the main burner on and off, and function
flame, fan, and light modulation. To deactivate this function,
1.
Verify all (3) AAA batteries are installed in the remote control.
2.
Remove (1) AAA battery.
3.
While reinserting the battery, push and hold the thermostat key.
The temperature bulb graphic will not be displayed on the LCD
screen.
•
To reactivate remote thermostat operation, follow the same key
sequence procedure above. The temperature bulb graphic will
reappear on the LCD screen.
62 OPERATING INSTRUCTIONS
10.9.8 Fan Speed Control
Fan speed can be adjusted through (6) speeds. To activate this
function,
1.
Press the mode key to index to the fan control icon.
2.
Press the up or down arrow keys to turn on, off, or to adjust fan
speed.
Thermostat mode:
fireplace is let. This allows time for heat to build in fireplace before
fan operation. The fan will continue to operate for approximately (12)
minutes after the fireplace has been turned off.
Manual mode:
in start up or stop time.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
Fan(s) have a (5) minute delay time when the
Fan(s) will operate at previous setting. There is no delay
#CLW-40 R.3 November 2021
Advertisement
Table of Contents
