ACME THUNDERBOLT User Manual page 11

Hide thumbs Also See for THUNDERBOLT:

Table of Contents

DMX Settings

Enter MENU mode, select DMX settings, confirm by pressing ENTER on, and use UP / DOWN on

to select: DMX Address, Ethernet Setup and Connect Option.

DMX Address

Select the DMX Address, press enter to confirm, and the current DMX Address will be displayed on the

display screen. Use the UP / DOWN button to select 001 ~ 512 Addresses, and press the ENTER button

to save. Press the MENU button to return to the previous MENU or wait 30 seconds to automatically

exit the menu mode.

Ethernet Setup

Select Ethernet Setup, press ENTER to confirm, and the current mode will be displayed on the display

screen. Select Network, Art-Net Settings or Sacn Settings through UP / DOWN button. When selecting

Network, select IP Address or Subnet Mask through UP / DOWN button. When selecting Art-Net

Settings , select Net, Sub-Net or Universe through UP / DOWN button, When the Art-Net setting is

selected, select the sACN Universe or sACN Priority the through UP / DOWN button, and press the

ENTER button to save. Each Network parameter of the lamp must be consistent with that on the

console before it can be controlled by the Network signal of the console. Press the menu button to

return to the previous MENU or wait 30 seconds to automatically exit the menu mode.

Connect Option

Select the Connect Option, press the ENTER button. The current mode will be displayed on the display

screen, which can be selected by UP / DOWN button: Auto, DMX, Art-Net or sACN, and press enter

button to save. Press the MENU button to return to the previous MENU or wait 30 seconds to

automatically exit the menu mode.

Channel Mode

Select the Channel Mode, press the ENTER button. Use the DOWN and UP button to select the Channel,

there are 11 channel Modes. Once selected, press the ENTER button to store. Press the MENU button

back to the last menu without any change or idling 30 seconds to exit menu mode.

DMX Last State

Select the DMX Last State, press the ENTER button. Use the DOWN and UP button to select Blackout or

Hold . Once selected, press the ENTER button to store. Press the MENU button back to the last menu

without any change or idling 30 seconds to exit menu mode.

10D

Table of Contents