Starting Lsi Corp Config Utility; Exiting Lsi Corp Config Utility - NEC Express5800 Series User Manual

4-6
Configuring Your Tape Blade

Starting LSI Corp Config Utility

Follow these steps to start LSI Corp Config Utility.
1.
Turn on the computer.
The following message will be displayed.
LSI Corporation MPT SAS2 BIOS
MPTBIOS-7.11.00.00 (2010.07.29)
Copyright 2010 LSI Corporation.
Press Ctrl-C to start LSI Logic Configuration Utility...
2.
Hold <Ctrl> key and press <C> key.
LSI Corp Config Utility starts and the "Adapter List" menu will be displayed.

Exiting LSI Corp Config Utility

Follow these steps to exit LSI Corp Config Utility.
1.
If you changed any settings, you are prompted to save the changes before you exit.
At the prompt, select the item which you want, press <Enter> key.
xxxxxxxx xxxxxxxx changes have been made.
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
2.
At "Adapter list" menu, press <ESC> key until a message prompts you to exit
At the prompt, select the item which you want, press <Enter> key.
Are you sure you want to exit?
Cancel Exit
Save changes and reboot.
Discard changes and reboot.
Exit the Configuration Utility and Reboot
Any changes made in LSI Corp Config Utility will take effect the next time the computer
is rebooted.