NEC Express5800 Series User Manual page 104

9-8
Upgrading Your Tape Blade
IMPORTANT:
Do not make your body contact with the terminals on the board.

Some malfunction may occur if the board is installed with dirt
and/or oil adhering to the terminals.
Insert the mezzanine card straight into the connector. The terminal

or connector may be damaged if it is inclined.
If the board cannot be installed securely, remove the board once and

then install it again. Adding excess force to the board may cause the
board to be damaged.
8.
Push the connector portion of the mezzanine card with fingers firmly to connect the card
to the slot.
9.
Tighten the fixing screws to fix the mezzanine card to the Tape Blade.
10.
Install the top cover having been removed.
11.
Secure the top cover with two screws.
12.
Install the Tape Blade having been removed to the Blade Enclosure.
13.
Turn on the power of the CPU blade. Make sure that any error messages associated with
the board do not appear on the POST screen.
Refer to the User's Guide of CPU Blade for details of POST error messages.
14.
Run BIOS SETUP of CPU blade, and select [Advanced] – [Reset Configuration Data] on
the [Advanced] menu and set to [Yes].
This is required to update the hardware update information. Refer to the User's Guide of
CPU Blade for details.
15.
Run the BIOS configuration utility of the installed board to provide setup for the board.
The existence of the utility and its start and operation procedures vary depending on the
type of the board. Refer to the documentation coming with the board for details.