Advertisement
PARTS REQUIRED:
3
Install first 47-7/8" x 48" roof
panel flush to the installed panel
and flush at the peak (Fig. B).
Secure panel with (1) 2" nail
in each corner.
Move to the opposite end.
Using the unattached end of
the panel as a lever, move the
panel side-to-side until the
top corner is flush to the peak
(Fig. B) and there is a 3/4"
measurement on the rafter
(Fig A).
Finish securing panel with (1)
2" nail in each corner.
4
Install next 48" x 48" roof panel flush
to the installed panel and flush at the
peak (Fig. B).
Secure panel with (1) 2" nail in each
corner.
Move gable end rafter edge until it is
1/2" from the 2nd 48" x 48" roof panel
(Fig. C).
Finish securing panel with (1) 2" nail
in each corner.
5
Install 27-7/8" x 48" roof panel flush
to the installed panel and flush at the
peak (Fig. B).
Secure panel with (1) 2" nail in each
corner.
Move gable end rafter edge until it is
1/2" from the 2nd 48" x 48" roof panel
(Fig. C).
Finish securing panel with (1) 2" nail
in each corner.
10' x 18' ROOF PANELS
7/16 x 48-7/8 x 48"
x2
(1,1 x 121,6 x 121,9 cm)
1/2"
(1,2 cm)
Gable
End Rafter
Fig. C
(1,9 cm)
Fig. A
7/16 x 23-7/8 x 47-7/8"
x1
(1,1 x 60,6 x 121,6 cm)
Flush
3/4"
Gauge Block
2" nail
in each
corner
57
x12
2" (5,1 cm)
Fig. B
Flush
in each
Fig. B
Flush
1/2"
(1,2 cm)
Gable
End Rafter
Flush at
peak
2" nail
corner
Flush at
peak
Fig. C
Advertisement
