Advertisement
PARTS REQUIRED:
7/16 x 48-7/8 x 48"
x1
(1,1 x 121,6 x 121,9 cm)
Gable
End Rafter
3
Install 48" x 47-7/8" roof panel
flush to the installed panel and
flush at the peak (Fig. B).
Secure panel with (1) 2" nail in
each corner, as shown.
4
Move gable end rafter edge until it is 1/2"
from the 48" x 47-7/8" roof panel (Fig. C).
Finish securing panel with (1) 2" nail in the outside corners.
Repeat STEPS 3 - 4 to install the
23-7/8" x 48" roof panel, as shown.
5
Maintain spacing between the center of the rafters at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter, as shown.
Move to the top of the panel and keep spacing between
the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8"
(61,9 cm)
(60,9 cm)
10' x 14' ROOF PANELS
x1
1/2"
(1,2 cm)
Fig. C
NOTE:
Measurements from inside of gable panels
24"
24"
(60,9 cm)
2" (5,1 cm) Nails
7/16 x 23-7/8 x 47-7/8"
(1,1 x 60,6 x 121,6 cm)
Flush
2" nail
in each
corner
Fig. D
24"
24"
(60,9 cm)
(60,9 cm)
53
x16
2" (5,1 cm)
Flush at
Fig. B
Fig. C
End Rafter
24"
24-3/8"
(60,9 cm)
(61,9 cm)
peak
1/2"
(1,2 cm)
Gable
Advertisement
