Advertisement
PARTS REQUIRED:
x1
Roof panels may cause serious injury until securely fastened.
Note: Install all roof panels with the rough side up (painted grid lines).
BEGIN
1
Place the 48" x 96" panel on rafters with a
1/2" measurement on the gable end rafter
(Fig. A), and with the panel flush
at the peak (Fig. B).
Secure panel with (1) 2" nail in each corner.
2
Move to the opposite end.
Using the long edge of the panel as a lever,
move the panel side-to-side until the top corner
is flush to the peak (Fig. B) and there is a 3/4"
measurement on the rafter (Fig. C).
Secure panel with (1) 2" nail in each corner.
Gauge Block
10' x 10' ROOF PANELS
7/16 x 48 x 96"
(1,1 x 121,9 x 243,8 cm)
Two Nails
3/4"
(1,9 cm)
Fig. C
3/4" GAUGE
BLOCK
Fig. B
48
x4
2" (5,1 cm)
Fig. B
Two Nails
Fig. A
Flush at
peak
Flush at
peak
1/2"
(1,2 cm)
Gable
End Rafter
Advertisement
