Fiber Port Speed Setting; Interface - Port Mirroring; General Information; Table 21 Wbm "Configuration" Page - "Fiber Port Speed Setting" Tab - WAGO 852-1328 Product Manual

Configuration in the WBM

10.4.5.2 Fiber Port Speed Setting

The description of each parameter and its default value in Fiber Port Speed Setting tab
page are summarized in Table "WBM "Configuration" Page – "Fiber Port Speed Setting"
Tab".
Parameters
Ports
Speed
10.4.6 Interface – Port Mirroring

10.4.6.1 General Information

Port-based mirroring is used on a network switch to send a copy of the network packets
sent or received by one or a range of ports to a network monitoring system connected to
another port (monitor port).
This is often used for network devices that require monitoring of network traffic, such as
an intrusion detection system (IDS).
Port mirroring, together with a network traffic analyzer, assists in monitoring network traf-
fic. Users can monitor the selected ports (source ports) for egress and ingress packets.
44 Product manual | Version: 1.2.0
Industrial Managed Switch
Figure 30: WBM "Configuration" Page – "Fiber Port Speed Setting" Tab
Table 21: WBM "Configuration" Page – "Fiber Port Speed Setting" Tab
Factory Default Description
- Fiber port number on the industrial managed switch. The user can
click on the dropdown list to select either Port 7 or Port 8.
1000 The user can change the port speed as either 1000 Mbit/s (1 Gbit/
s) or 100 Mbit/s from the drop-down list. Click the [Submit] button
to apply the speed change.
852-1328