WAGO 852-1328 Product Manual page 40

Configuration in the WBM
Parameter
Time
Daylight Saving Settings
Enable State
Start Day
End Day
Mode: Network Time Protocol
Select Network Time Protocol mode to enable SNTP. An NTP server must then be speci-
fied.
40 Product manual | Version: 1.2.0
Industrial Managed Switch
Description
Select the time in the format hour/minute/second that you are manually setting for the
system.
Select Enable to enable Daylight Saving Settings or Disable to disable Daylight Saving
Settings.
Enter the date and time for the start of daylight saving time if you have activated this op-
tion. The time is displayed in 24-hour format.
Enter the date and time for the end of daylight saving time if you have activated this op-
tion. The time is displayed in 24-hour format.
Figure 27: WBM "Configuration" tab – "SNTP" page
852-1328