Connecting And Disconnecting Nexa Smart Plugs; Connect A Nexa Smart Plug In Actuator Pairing Mode - Tunstall Lifeline Digital User Manual

• Two long beeps indicate that the peripheral is not
connected and the battery is low and must be re-
placed.
e) Press the green Cancel button (3) to exit the radio test
or the radio test automatically ends after approx. 60 sec-
onds.

4.7. Connecting and disconnecting Nexa smart plugs

This section describes how to connect and disconnect Nexa Smart plugs. Lifeline Digital transmits an "ON" code to
connect to the Smart plug, and an "OFF" code to disconnect the Smart plug. The Smart plug does not transmit to
Lifeline Digital.
Lifeline Digital supports up to 16 actuator output channels. More than one Nexa Smart plug can be associated with
one channel.

4.7.1. Connect a Nexa smart plug in actuator pairing mode

NOTE
To simplify this procedure, connect a light to the Smart plug. When the Smart plug is paired to the
device, the light will remain switched on.
To connect a Nexa smart plug:
a) Enable programming mode, see Enable programming
mode, page 20.
b) Press and hold the yellow Extra button (1).
c) When the device announces "Eight", release the button.
d) When the device announces "Select radio channel",
press and hold the yellow Extra button (1).
The device announces numbers in ascending order,
starting from "One".
e) When the device announces the number of the actuator
output channel that you want to select, release the but-
ton.
The device starts to emit consecutive beeps to indicate
that it is sending the ON code.
1
31
3