4. Configuration and testing
This section describes how to configure and test Lifeline Digital using the buttons on the keypad.
4.1. Connecting Lifeline Digital
4.1.1. Remove and replace the back cover
NOTE
Only remove the back cover for installation, configuration, or maintenance. The back cover protects
the device from tampering.
To remove and replace the back cover:
a)
Push and slide out the back cover to remove it (1).
b)
Run all cables through the cable slot (2).
c)
Replace the back cover when installation, configuration
or testing is completed (3).
4.1.2. Connect the Ethernet cable
An Ethernet connection is required for wired IP communication.
NOTE
The Ethernet cable is not supplied by Tunstall.
To connect an Ethernet cable:
a)
Insert the Ethernet cable into the Ethernet port on the
device (1).
b)
Connect the other end of the Ethernet cable into the lo-
cal internet router or network socket.
1
18
3
2
1