Advertisement
ENGINE
Model
INTEK
Displacement
500 cc (30,5 cu in.)
Model
INTEK
Displacement
656 cc (40,0 cu in.)
Electrical System
Alternator: 9 amp Regulated
Battery: 12V-195 CCA
Oil Capacity
1,4 L (48 oz) or 1,9 L (64 oz)
Engine Oil
Synthetic 5W30
Spark Plug Gap
0,76 mm (0.030 in.)
Spark Plug Torque
20 Nm (180 in-lbs)
Fuel Tank Capacity
13,2 L (3.5 gal)
*This spark ignition system complies with Canadian ICES-002.
CHASSIS
Seat Adjustment
9-Position
Front Wheels
Tire Size: 15 x 6.0-6
Inflation Pressure: 12-14 psi (0,82 -0,96 bar)
Rear Wheels
Tire Size: 20 x 8.0-8
Inflation Pressure: 10 psi (0,68 bar)
Tire Size: 20 x 8.0-10
Inflation Pressure: 10 psi (0,68 bar)
Power Ratings
The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995.
Torque values are derived at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others;
horsepower values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.
COM. Net power values are taken with exhaust and air cleaner installed whereas gross power values are collected
without these attachments. Actual gross engine power will be higher than net engine power and is affected by, among
other things, ambient operating conditions and engine-to-engine variability. Given the wide array of products on which
engines are placed, the gasoline engine may not develop the rated gross power when used in a given piece of power
equipment. This difference is due to a variety of factors including, but not limited to, the variety of engine components
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions
(temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs &
Stratton may substitute an engine of higher rated power for this engine.
Parts and Accessories
Contact an Authorized Service Dealer.
4175 Series
TM
TM
7220 Series
TM
TM
TRANSMISSION
Make
Type
Make
Type
MOWER DECK
Cutting Width
Base Deck Platform
Number of Blades/Type
Frame Suspension
Deck Support Wheels/Number Standard, 4 Anti-Scalp Wheels
Height-of-Cut
Mower Lift
Cutting Positions
Specifications
Hydro-Gear®
T2HP
Tuff Torq® Hydrostatic
K46
107 cm (42 in.)
117 cm (46 in.)
Side Discharge
2 or 3, Standard Lift
Frame Hung
1.5 to 4.0 in. (3,8 to 10,2 cm)
Manual
6
en
23
Advertisement
