Advertisement
Features and Controls
See Figure 2 for location.
Throttle/Choke Control
(Choke-A-Matic)
The throttle/choke controls the engine speed and choke
(see Figure 2). Move the throttle/choke control to the FAST
position to increase engine speed and SLOW position to
decrease engine speed. Always operate at full throttle.
Move the throttle/choke control to the CHOKE position
for starting a cold engine. A warm engine may not require
choking.
Headlights
The light switch turns the tractor headlights on and off.
Reverse Mowing Option (RMO)
The Reverse Mowing Option allows for mowing (or use of
other PTO driven attachments) while traveling in reverse.
If you choose to mow or operate another attachment in
reverse, turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow in
reverse. Each time the PTO is disengaged the RMO needs
to be reactivated if desired.
PTO Switch
The PTO (Power Take-Off) switch engages and disen-
gages attachments that use the PTO. To engage the PTO,
pull UP on the switch. Push DOWN to disengage. Note that
the operator must be seated firmly in the tractor seat for the
PTO to function.
Ignition Switch
The ignition switch starts and stops the engine, it has three posi-
tions:
OFF
Stops the engine and shuts off the
electrical system.
RUN
Allows the engine to run and powers the
electrical system.
START
Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN position
with the engine stopped–this drains the battery.
Brake Pedal
Depressing the brake pedal applies the tractor brake.
12
Ground Speed Pedals
The tractor's forward ground speed is controlled by the
forward ground speed control pedal. The tractor's reverse
ground speed is controlled by the reverse ground speed
control pedal.
Depressing either pedal will increase ground speed. Note
that the further down the pedal is depressed, the faster the
tractor will travel.
Cruise Control
The cruise control is used to lock the ground speed control
in forward. The cruise control has five lock positions.
Mower Height of Cut Adjustment
The mower cutting height adjustment lever controls the
mower cutting height. The mower cutting height can be set
to one of seven positions between 1.5 and 4.0 in. (3,8 and
10,2 cm).
Seat Adjustment Lever
The seat can be adjusted forward and back. Move the
lever, position the seat as desired, and release the lever to
lock the seat into position.
Transmission Release Lever
The transmission release lever deactivates the transmis-
sion so that the tractor can be pushed by hand. See Push-
ing the Tractor by Hand section.
Fuel Tank
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the fuel level in the tank.
Parking Brake
The parking brake knob is used to lock the parking brake
when the tractor is stopped. Fully depressing the brake
pedal and pulling up on the knob engages the parking
brake.
Advertisement
