Managing The Power Supply System - H3C S12500 Installation Manual

To reboot cards or switches immediately at the CLI:
Task
In standalone mode, reboot a
card, or the switch
immediately.
In IRF mode, reboot an IRF
member switch, a card on the
switch, or all IRF member
switches.
To schedule a reboot:
Task
Specify the reboot date and
time.
Specify the reboot delay time.

Managing the power supply system

You can use the following display commands and proper configuration commands to manage the
power supply system of your switch.
Displaying the electrical label data for the power monitoring
module
Use the display device manuinfo power-monitor command to display the electrical label data for
the specified power monitoring module.
•
In standalone mode:
# Display the electrical label information about power monitoring module 2.
<Sysname> display device manuinfo power-monitor 2
Power Monitor unit 2:
DEVICE_NAME
DEVICE_SERIAL_NUMBER : 210235A36L1234567890
MAC_ADDRESS
MANUFACTURING_DATE
VENDOR_NAME
•
In IRF mode:
Command
reboot [ slot slot-number ]
[ force ]
reboot [ chassis chassis-number
[ slot slot-number ] ] [ force ]
Command
schedule reboot at time [ date ]
schedule reboot delay time
: PMU
: NONE
: 2010-01-20
: H3C
57
Remarks
Available in user view.
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the switch.
Available in user view.
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the member switch.
Remarks
Available in user view.
By default, the scheduled reboot
function is disabled.
You can use either one of these
commands to schedule reboot time for
a standalone switch or all member
switches in IRF mode.
The reboot schedule becomes invalid
in the following cases:
•
An active and standby switchover
occurs in standalone mode.
•
An active and standby switchover
occurs on the master switch in
IRF mode.