H3C S12500 Installation Manual page 97

•
If the cable cannot be removed or installed, verify that the removal or installation procedures are
correct.
•
When you remove a cable, pull the pull latch horizontally. Otherwise, the cable cannot be
removed smoothly, or even the module or slot could be damaged.
To replace an SFP+ cable:
Put on an ESD wrist strap, and make sure it has close skin contact and is correctly grounded.
1.
Gently press the cable connector in, and then pull the pull latch on the cable outward to pull out
2.
the cable connector.
Figure 78 Removing the SFP+ cable
Unpack the SFP+ cable to be installed.
3.
Gently insert the cable connector into the SFP+ port.
4.
Install the connector at the other end of the SFP+ cable into the SFP+ port on the peer device in
the same way.
Figure 79 Installing the SFP+ cable
89