Replacing A Transceiver Module - H3C S12500 Installation Manual

Replacing a transceiver module

Replacing the XFP, SFP+, SFP, and QSFP+ modules
CAUTION:
Do not touch the golden finger of a transceiver module during replacement.
The replacement procedures for the XFP, SFP, SFP+, and QSFP+ modules are similar. This section
uses an SFP+ module as an example.
To replace a transceiver module:
Put on an ESD wrist strap, making sure that the strap makes good skin contact and is correctly
1.
grounded.
Remove the optical fibers from the SFP+ module, pivot the clasp down to the horizontal position,
2.
and then pull the SFP+ module out of the port, as shown in
Figure 74 Removing the SFP+ module
1
Put the removed SFP+ module in an antistatic bag or its original shipping materials.
3.
Unpack the SFP+ module to be installed and make sure the clasp is closed.
4.
Remove the optical fiber, if any, from the SFP+ module before installing it.
5.
Gently insert the SFP+ module into the port until it fits in completely, as shown in
6.
Connect the optical fibers to the new SFP+ module.
7.
Figure 75 Installing an SFP+ module
2
87
Figure 74.
Figure 75.