Prosense DPX Series User Manual page 9

Wall mounting hole
Wall mounting hole
DPX8, DPX32, DPX64, DPX128 panel has 6 plastic screws on the front of panel. Use a flat
screwdriver to lose them and remove the cover part on the front. Please take care and
remove the connectors on the electronic card while removing the cover. Fix the panel on the
wall via using 6 screw holes after removing the front cover. Reattached the front cover and
tighten 6 plastic screws when wall mounting completed.
To prepare cable entries, remove plastic covers from top or bottom on the panel. Then drill
the holes for cable entry and install cable glands to the holes you made it. Make sure you are
using an adequate IP66 rate cable gland to assure the box ingress protection is not
compromised. The panel box is modular and can be used with different assemblies. Prosense
recommends having cable entries from the lower side. Electronic board is located in the
front cover of the panel. The power supply is located at the back of panel box. The power
must be connected to this power supply. If the installation requires the connection to a
backup battery, place the battery to lover right side of the panel inside.
PRS-UM-DP-X-EN-Rev1.0-17.11.2021
Backup battery connectors and fuse
Power supply
N L G V- V+
Power supply LED
Diagram 5: Panel body
Space for backup
batteries
Main power entry and fuse
Wall mounting hole
Power supply output
adjustment switch
Wall mounting hole
9