Installation - Prosense DPX Series User Manual

4 Installation

The DPX Series Gas Control Panel should never be placed in an explosive atmosphere and
should be readily accessible. It is necessary to drill holes for cable glands either on the top or
bottom of the control unit, depending on which side the electric cables are running in.
Before drilling any holes you can unscrew and remove the electronic parts to avoid
accidentally damaging it. DPX Series Gas Control Panel should not be placed nearby high
voltage cables or power cable, coaxial cables or transmitters, welding stations or frequency
regulators.
DPX Series Gas Control Panel box produced based on IP66 standard specifications. Always
use the screw holes to mount it and do not pierce panel from any other side. Always use
cable glands to make cable entries.
S-DPX4 panel has 4 plastic screws keeping panel door in place in front of panel. Use a flat
screwdriver to lose them and remove the panel door assembly. Please take care and remove
the connectors on the electronic card while removing the cover. Fix the panel on to the wall
via using 4 screw holes in each corner after removing the front cover. M4 screws are suitable
to fix the panel body to the wall. Once wall mounting completed reattached the front cover
and tighten 6 plastic screws.
Plastic screws Plastic screws
Diagram 4: Panel cover plastic screw
To prepare cable entries, remove plastic cover from top or bottom on the panel. Then drill
the holes for cable entry and install cable glands to the holes you made it. Make sure you are
using an adequate IP66 rate cable gland to assure the box ingress protection is not
compromised. The panel box is modular and can be used with different assemblies. Prosense
recommends having cable entries from the lower side. Electronic board is located in the
front cover of the panel. The power supply is located at the back of panel box. The power
must be connected to this power supply. If the installation requires the connection to a
backup battery, place the battery to lover right side of the panel inside.
8
PRS-UM-DP-X-EN-Rev1.0-17.11.2021