Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
With the exception of the crank handle and stand
legs, the slip roll is fully assembled when shipped.
To assemble machine:
1.
Place shipping crate near installation loca-
tion, then remove crate top and sides and set
small items aside.
2.
Unbolt machine from shipping pallet.
3.
Place crate top on ground near machine to
protect machine in next step.
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
4.
With help from assistants, move slip roll off
of pallet and onto crate top and orient it on
its side so model number label faces up (see
Figure 6).
-12-
HEAVY LIFT!
5.
Attach (2) legs to slip roll, as shown in Figure
6, with (8) M8-1.25 x 25 cap screws, (16)
8mm flat washers, (8) lock washers, and (8)
M8-1.25 hex nuts.
x 8
Leg
(1 of 2)
Figure 6. Legs attached to slip roll.
6.
Place lifting straps around and under rollers
at locations shown in Figure 7. Straps should
spread as wide as possible.
Figure 7. Lifting straps placed around and under
rollers.
Model T32718 (Mfd. Since 07/21)
Advertisement
Table of Contents
