Graco PrecisionFlo XL Instructions Manual page 5

FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
D Ground the equipment and the object being sprayed. See Grounding the Control Assembly on
page 15.
D If there is any static sparking or you feel an electric shock while using the equipment, stop dis-
pensing immediately. Do not use the equipment until you have identified and corrected the prob-
lem.
D Make sure all electrical work is performed by a qualified electrician only.
D Have any checks, installation, or service to electrical equipment performed by a qualified electrician
only.
D Make sure all electrical equipment is installed and operated in compliance with applicable codes.
D Do not install the PrecisionFlo XL module in a hazardous area, as defined in Article 500 of the
National Electrical Code (USA).
D Turn off power to the PrecisionFlo XL module before disconnecting any cables connected to the
control unit or other components.
D Disconnect electrical power at the main switch before servicing the equipment.
D Keep the dispensing area free of debris, including solvent, rags, and gasoline.
D Before operating the equipment, extinguish all open flames or pilot lights in the dispense area.
D Do not smoke in the dispensing area.
D Disconnect the electrical cables from the PrecisionFlo XL metering valve before servicing the
valve.
D Keep liquids away from the electrical components
WARNING
Warnings
309374 5