Graco PrecisionFlo XL Instructions Manual page 4

Warnings
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and
INSTRUCTIONS result in serious injury.
D This equipment is for professional use only.
D Read all instruction manuals, warnings, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose. If you are uncertain about usage, call the
distributor closest to you. See the Graco Phone Number on page 156 for information.
D Only use the PrecisionFlo XL fluid modules with the PrecisionFlo XL control unit.
D Only use a dispensing device appropriate for the fluid and application method, and capable of
operating at the highest possible fluid supply pressure the module may experience.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily. Repair or replace worn or damaged parts immediately.
D Do not disassemble the PrecisionFlo XL metering valve motor. The motor contains powerful
magnets, which could attract metal objects and create a hazardous condition if the motor end
plates are removed. Contact your Graco distributor for motor service.
D Do not exceed the maximum working pressure of the lowest rated system component.
D Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco ambient hoses to temperatures above 180_F (82_C) or below –40_F (–40_C).
D Do not use the hoses to pull the equipment.
D Use only fluids that are compatible with the equipment wetted parts. See the Technical Data
sections of all the equipment manuals. Read the fluid manufacturer's warnings.
D Comply with all applicable local, state and national fire, electrical and other safety regulations.
D Do not touch the metal heat sink on the metering valve when the surface is hot.
D Do not cover the PrecisionFlo XL linear metering valve; the motor needs air ventilation for
cooling.
D Do not attempt to modify the programming of the module. Any modification of the programming
could result in serious injury or damage to the module.
MOVING PARTS HAZARD
Moving parts, such as the fluid needle, can pinch fingers.
D Do not operate the equipment with the guard removed.
D Keep clear of any moving parts when starting or operating the equipment.
4 309374
WARNING