IONODES ION-R200 User Manual page 19

19
network interface as not connected, check the Ethernet cable between the ION-R200 and the network before
proceeding.
By default, the ION-R200 is configured in DHCP mode. If a DHCP server is present on the network, the network
configuration provided by the DHCP server is displayed. In that case, nothing needs to be done; the device is
ready to communicate with computers and cameras on your network.
If the IP address shown is in the range 169.254.*.*, this means that the device could not obtain its network
configuration from a DHCP server. In that case, the network configuration must be set manually.
To set the network configuration manually, uncheck Use DHCP. You can then enter each network setting
separately. If you are unsure what values to enter, ask your network administrator to provide configuration
settings compatible with your network. At a minimum, a valid IP address and Subnet mask must be entered.
Once this is done, click on Save at the bottom to apply the configuration changes.
support@ionodes.com | www.ionodes.com | 450-696-1060