Fig. 8-26 Remote Setpoint Menu/Settin Spl & Sph - Hardy Process Solutions HI 2160RC PLUS Operation And Installation Manual

Step 6. Setting a Percentage of the HI Output Signal. (See Fig. 8-24)
• The HI 2160RC
ator to quickly change the HI Output Signal in order to
reduce the flow rate, without changing the HI Output Sig-
nal. For Example:
The HI output signal setting is 10.00 LBS/MIN. The pro-
cess slows down and the feed rate required is only 9 LBS/
MIN. You can set the Set Point Percentage at 90% of the
HI output signal and the HI 2160RC PLUS slows the
feeder rate to 9 LBS/MIN. If the process requires 5.7
LBS/MIN, set the percentage for 57%, 6.3 LBS/MIN, set
the percentage for 63%, etc.
• Press the Config button. The Main Menu appears.
Press the down arrow ↓ until the cursor is to the left of the
•
Remote Set Point sub-menu.
• Press the Enter button. The Set Point Menu appears with
the cursor next to the Percentage sub-menu. (See Fig. 8-
25)
• Press the Clear button to clear the value. A setting of 0.00
= 100% output signal.
• Use the numeric keys to enter the new percentage parame-
ter.
• Press the Enter button to accept the new percentage.
Step 7. Setting the Set Point Low (SPL) parameter. (See Fig. 8-25)
FIG. 8-26 REMOTE SETPOINT MENU/SETTIN SPL & SPH
Chapter 8 - Operation
PLUS Percentage Function allows the oper-
R E M O T E SE T P O I NT M E NU
A V ER A G E S ( 1 - 2 0) 2 0
S P L 1 . 0 0 0 L B S / M I N
S P H 2 . 00 0 L BS / M I N
8-23