Setting Up The Analog Output Option; Fig. 6-39 Tuning/Control Menu/Setting Control Out Hi Percentage/74 - Hardy Process Solutions HI 2160RC PLUS Operation And Installation Manual

Setting Up the Analog
Output Option
FIG. 6-39 TUNING/CONTROL MENU/SETTING CONTROL OUT HI
Step 20. Press the Enter button to accept the new value.
Step 21. The operator cannot set a flow rate higher than 74% of full
span which equates to 11.6 lbs/m in our example. If a flow
rate is entered higher than 11.6 lbs/m an error statement
appears "SETTING TOO HIGH".
Step 22. Press the Exit button to return to the Main Menu.
Step 23. Press the Exit button to return to the Operating Display.
• The Analog Output Option contains user-scaled calibration data
used to transmit information to a PLC, recorder, remote display, or
similar devices accepting analog input signals.
Step 1. From the Main Menu press the down arrow ↓ button until the
cursor is to the left of the Analog Output Sub-Menu. (See Fig.
6-40)
T U NI N G / CO N T RO L ME N U
C T L . O UT L O ( % ) 2 6
C T L . O UT H I ( % ) 7 4
A VR G . (1 - 20 0 ) 2 00
PERCENTAGE/74
Chapter 6 - Setup
6-45