Hardy Process Solutions HI 2160RC PLUS Operation And Installation Manual page 142

SUB- DATA
COMMAND
CMD FORMAT
S AT 0
S BA XXXXXX
S CA
S D1 XX.X YYY
S D2 XX.X YYY
S D3 XX.X YYY
S D4 XX.X YYY
S D5 XX.X YYY
S DX
S DX
S KD XXXXX
S KI XXXXX
S KP XXXXX
S KT XXX
S MD MMDDYY
S MO X
S RAH XXXXXX
S RAL XXXXXX
S RAT XXXX
S RCHP
S RCHR
S RCLP
S RCLR
S RSH XXXXXX
S RSL XXXXXX
S SP
S SS XXXXXX
S ST
S SU
TABLE 7-1: S (SET) COMMANDS LISTED ALPHABETICALLY WITHIN SUB-COMMAND
DESCRIPTION OF COMMAND
Set Accumulated Total to 0 (clear total register)
Set Batchpoint Batch Amount (must be set mode to BATCH instead of Con-
tinuous.
Clear Alarms
Run at Manual Output of xx.x% for yyy seconds (leading zeros required).
Run at Manual Output of xx.x% for yyy seconds (following S D1 command).
Run at Manual Output of xx.x% for yyy seconds (following S D2 command).
Run at Manual Output of xx.x% for yyy seconds (following S D3 command).
Run at Manual Output of xx.x% for yyy seconds (following S D4 command).
Clear all previous data-logging commands.
Clears all previous data logging commands (D1-D5).
Set K Derivative Tuning Parameter (leading zeros required).
Set K Integral tuning Parameter (leading zeros required).
Set K Proportional Tuning Parameter (leading zeros required).
Set Timebase (selections: 1-6, 8, 10, 12, 15, 20, 30, 40, 50, 60, 120; leading
zeros required.
Set Date in Month-Day-Year Format (leading zeros required).
Set Setpoint Mode (Selection: 1-6, See Data Transmission format for X M
command.
Set Rate Tolerance HI ALARM (up to 6 digits, include decimal point if used).
Set Rate Tolerance LO ALARM (up to 6 digits, include decimal point if
used).
Set Rate Tolerance Alarm Time in Seconds (0000-0999 seconds, leading
zeros required).
Rate Calibration High Percentage
Rate Calibration High Rate
Rate Calibration Low Percentage
Rate Calibration Low Rate.
Set Rate Tolerance HI SHUTOFF (up to 6 digits, include decimal point if
used).
Set Rate Tolerance LO SHUTOFF (up to 6 digits, include decimal point if
used)
Set 2160 Status to STOP (OFF).
Set Setpoint Rate in Automatic Mode (up to 6 digits, include decimal point if
used).
Set 2160 Status to START (ON).
Set 2160 Status to PAUSE (HLD).
2. Request Commands (Xmit) for data from the controller.
Chapter 7 - Serial Communications
7-3