Programmed Scan Operation; F Scan Operation - Icom IC-756 Instruction Manual

Programmed scan operation

q If the start up screen is not selected (if [F-5]'s func-
tion is [EXIT]), push [F-5] one or more times to exit.
w Select VFO mode.
e Select the desired operating mode.
- The operating mode can also be changed while scan-
ning.
r Push [
SCAN] to select the scan screen.
(F-4)
14.195.00
14.205.00 14.205.00
t Set [RF/SQL] open or closed.
- See previous page for scan condition.
- If the [RF/SQL] control function is set as RF control, the
squelch always opens. See pgs. 2, 56 for details.
∂ ∂ F scan operation
q If the start up screen is not selected (if [F-5]'s func-
tion is [EXIT]), push [F-5] one or more times to exit.
w Select VFO mode or a memory channel.
e Select the desired operating mode.
- The operating mode can also be changed while scan-
ning.
r Push [
SCAN] to select the scan screen.
(F-4)
14.195.00
14.205.00 14.205.00
t Set [RF/SQL] open or closed.
- See previous page for scan condition.
- If the [RF/SQL] control function is set as RF control, the
squelch always opens. See pgs. 2, 56 for details.
y Push [
PROG] to start the programmed scan.
(F-1)
- Decimal points blink while scanning.
14.195.00
14.205.00 14.205.00
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
i To cancel the scan, push [
NOTE: If the same frequencies are programmed
into the scan edge memory channel P1 and P2,
programmed scan does not start.
y Set the ∂F span by pushing [
u Set center frequency of the ∂F span.
i Push [
∂F] to start the ∂F scan.
(F-2)
- Decimal points blink while scanning.
14.195.00
14.205.00 14.205.00
o When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
!0 To cancel the scan, push [
6
SCANS
PROG].
(F-1)
∂F SPAN].
(F-4)
∂F].
(F-2)
48