Select Memory Scan Operation; Setting Select Memory Channels; Start Select Memory Scan - Icom IC-756 Instruction Manual

Select memory scan operation

q If the start up screen is not selected (if [F-5]'s func-
tion is [EXIT]), push [F-5] one or more times to exit.
w Select memory mode.
e Select the desired operating mode.
- The operating mode can also be changed while scan-
ning.
r Push [
SCAN] to select the scan screen.
(F-4)
14.195.00
14.205.00 14.205.00
t Set [RF/SQL] open or closed.
- See p. 47 for scan condition.
- If the [RF/SQL] control function is set as RF control, the
squelch always opens. See pgs. 2, 56 for details.

Setting select memory channels

q If the start up screen is not selected (if [F-5]'s func-
tion is [EXIT]), push [F-5] one or more times to exit.
w Select memory mode.
e Push [
SCAN] to select the scan screen.
(F-4)
14.195.00
14.205.00 14.205.00
r Select the desired memory channel to set as se-
lect memory channel.
y Push [
MEMORY] to start the memory scan.
(F-1)
- Decimal points blink while scanning.
u Push [
SELECT] to start select memory scan;
(F-3)
push [ SELECT] again to return to memory
(F-3)
scan, if desired.
14.195.00
14.205.00 14.205.00
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o To cancel the scan, push [
NOTE: 2 or more memory channels must be des-
ignated as select memory channels for select
memory scan to start.
t Push [
SELECT] to set the memory channel as
(F-3)
a select memory or not.
" " appears for select memory channels.
14.195.00
14.205.00 14.205.00
y Repeat steps r to t to program another memory
channel as a select memory channel, if desired.
u Push [
EXIT] to exit the scan screen.
(F-5)
NOTE: Select memory channels can also be set in
the memory channel screen. (p. 42)
6
SCANS
MEMORY].
(F-1)
50